Rizzo
Member
Any ideas on rod strap for new Z20 Pro?
It is almost impossible to use without bending your rods into a tight arc around the seat arm. Very poor design.What's wrong with the strap behind the seat?
You have to wonder how anyone rigging thought that was a good idea..... the way it is set up on the Z-18 is useless.It is almost impossible to use without bending your rods into a tight arc around the seat arm. Very poor design.
I saw those too, but I wonder with our short gunnels if they would work with the newer Z models.These are the retractable hold downs I found on Amazon.
https://smile.amazon.com/dp/B002IV8JZW/ref=cm_sw_r_cp_awdb_imm_MXYFKVW5KETRFBJYE2VM
awesome. any tips on cutting into the deck? how did you keep the carpet from running?I just added those last week to my 2021 Z19. Easy in deck install. Gunwales are too thin so I put them in the deck.
It comes with a template. I drilled a hole in each corner and used a med blade in a jig saw. Easy to cut but make sure you position it where there are no obstructions underneath. I positioned it to reuse one of the holes left by the factory loops I removed. You can easily see the underside through the rod lockers. I had no issue pulling the carpet but you could use a box cutter on the cut lines just as additional insurance. I got mine from Amazon because I couldn’t find any locally.I just added those last week to my 2021 Z19. Easy in deck install. Gunwales are too thin so I put them in the deck.
You can use a box cutter to cut through the cut lines before cutting the deck. I did not and experienced no pulling but probably would have been smart to precut the carpet.awesome. any tips on cutting into the deck? how did you keep the carpet from running?
Enter your email address to join: