Airbear72, I have this 2019 Z20 Pro, it measures 23'8" with the folding tongue, my garage measured 23'6" I of course have to turn the engine all the way to the port side and I tilt the engine until the prop is slightly further out than the cowl. I attached a plywood panel to the drywall and then screwed at rubber floor mat to the plywood, when I push the boat in the last foot the prop will touch the rubber and then spring back off it so there is no pressure against the prop or the hydraulic steering system. I cut a 1' section out of the 2 bottom ribs on the garage door, I'M IN!!!! I also added an electric screen closure to the outside of the cinder blocks so that adds another 12" of room. They sometimes recess those closures, I had them install it to the exterior. I also had 10' Talon's, I bought the tilt plates for them and installed them myself so I can tilt them and garage door height not an issue either.