2010 Z-7 structural issues

[Jason Martin]

has anyone had this problem? Got back from a fishing trip, and when I went to clean my rod lockers out I noticed the inside walls had seperated from the bottom of the locker. The same on both lockers. I can take my hand and push the inside wall out. I took the platic tras can out and could see on the port side that the fiberglass had broken and cracked down the bottom seam. I'm sure it is the same on the starboard side.

 

[Joe Potaczek]

Mine is not like that.

 

[joseph currier]

bring it to a dealer a.s.a.p. while it is under warrenty you want to document everything yourself as well as with the dealer.

you may have a bad hull? happens sometimes.resin doent cure properly because it was to humid that day or to hot or to cold or some other reason i know nothing about.

but sounds like you boat could be a canidate.

if this is the case dont worry tracker will give you a brand new hull

if the dealership says they can repair it and it continues to fail after that you want your own documentation.

good luck.

 

[TOMMY RICH]

Take Joe's advice and take it to the dealer ASAP! Pound on em' if ya' have to

 

[Bob Bourget2]

Agreed. The Dealer should take the appropriate pictures and submit them for warranty consideration. The folks at the Factory work hard to "make it happen". If it is a cosmetic issue, at least it will be on record if something should develop later on.