I'm not quite sure what to call it, but I'm looking for information on how the boat is built. I want to know where the wires are routed, and essentially how to strip the interior of the boat to a bare hull. I want to "disassemble" and reassemble it, not demo the interior and start over.
Specifically, I'm looking right now for diagrams showing how the front and rear decks are attached and how to take the top of the deck off. I'm looking for leaks, possibly remove thru-hull fittings seal them and reattach. Are the decks attached with screws or rivets? Where are those screws located?
i hope this makes sense.
Specifically, I'm looking right now for diagrams showing how the front and rear decks are attached and how to take the top of the deck off. I'm looking for leaks, possibly remove thru-hull fittings seal them and reattach. Are the decks attached with screws or rivets? Where are those screws located?
i hope this makes sense.