2002 Tracker PRO team 175xt... Looking for some help

[John Glaser]

Can someone tell me what size prop that I have on my 50HP..The prop was removed and I never had numbers

Where can I get a part number for the front pedestal (Rotted and Broke)

Looking to replace Black Trim around vessel Part Number?

Decals?

I want to replace these items before polishing and sharkhiding...

Thanks in advance

Woody

 

[Greg Meyer]

I can help you with the prop issue... Go to the link, below and answer the questions and it will suggest the right prop "Prop Wizard".



And, I can genuinely recommend the "Turning Point Props". I have used them for ten years with no complaints and a high degree of satisfaction.
http://www.turningpointpropellers.com/

 

[Rick (ewop) hanks]

Hello woody, I have an o4 pt 175 with a 50 merc. on it and have used merc props with pitches from 9 to 13 pitch. I have found that the 12 pitch prop works best for my boat. On plane instantly, top speed close to 35mph on gps. I finally found a stainless merc. prop in stainless,that was under 200.00 and I truly love it. hope this might help. rick

 

[Rick (ewop) hanks]

Sorry forgot to mention, go to" tracker boat" on EBAY they have alot of original decals listed. rick

 

[John Glaser]

Thanks on the prop suggestion...

Is there anywhere that you folks have dealt with for Tracker parts ?

I discovered I also need the plastic Y yolk that supports the motor while trailering and have looked on the internet for that and the pedistal parts... Decals can wait if need be

Can anyone help?

Best Regards and thanks

Woody

 

[Scott R]

Where can I get a part number for the front pedestal (Rotted and Broke)

When you say the pedestal "rotted and broke", are you talking about the seat post rotted and broke, or the area around the hole in the deck (pedestal base) where the post inserts is what rotted and broke? If it is the seat post, you can get them at WalMart, BPS, just about any marine store. If it is the piece in the deck, you will need more than the pedestal base...you'll need to replace the decking material also. You can get the pedestal bases at BPS, Cabelas, or nearly any marine store (see link below). You'll just have to know which base or pedestal you have.

http://greatlakesskipper.com/category-1/99-seat-pedestals-and-parts.html

Looking to replace Black Trim around vessel Part Number?

Check the link below...they are about the only place to find older Tracker parts

Decals?

See above

I discovered I also need the plastic Y yolk that supports the motor while trailering and have looked on the internet for that and the pedistal parts

Are you talking about a transom saver?

If so, WalMart, BPS, etc carries them also.
http://greatlakesskipper.com/brands-1/158-tracker-marine-group.html