Search results

I may have misunderstood you. If you need to keep edges down, there are numerous rubber/plastic trim option that are sold by the foot. Make sure it has peel and stick. In the corners, i used black aluminum rivets to keep it connected to boat fiberglass. If u need pictures, just let me know and...

I recarpeted 2001 929cdx last year. i didnt have any screws like you mentioned i would not remove. They may be holding a support bracket under deck as reinforcement. If they were visible above carpet, most likley the prevoius boat owner used them to hold carpet down. Was that area of carpet...

Thinking about purchasing an Inverter Generator (2000w) to charge boat batteries when electric outlet not available. I have a 3 bank 10 amp charger on board. Will this work? If not, any recommendations would be appreciated. Thanks for help.

Couple of thoughts/ideas...I always have my drainage plug open when boat is parked. Make sure your boat is as level side to side. If you have extra storage totes (full of fishing gear) like most of us, use your boat to store under cover to keep your boat cover tight so rain runs off and doesn't...

Give Todd Moore a call from www.thepelicanservices.com you may have "pinched" your tracker valve or fuel diaphragm when you replaced. not saying this is your issue, but it could be. he may be able to help diagnose and give you some help. I had a good experience with his service.

post a picture of your windshield. I have a couple for a nitro 929. Not sure if they are same or interchangeable.

J., What has worked for me with a Nitro 929 dual axle is when loading the boat, take notice of where your back tire (on tow vehicle) is in relation to the water edge when you boat starts to float. When you "load" boat , I like to back trailer in water until my bunks are completely submerged to...

i know this post is last year but, If you need any plastics lures, spinnerbaits give me a call. Jack 412-680-8935

Just a few tips to consider after you get a traveling cover...use small hand towels and small bungee cords to cover the following stressed areas- trolling motor base, any fishfinder brackets at front or driver side, and throttle lever. Cut to length a piece of pipe insullation foam (or small...

Bob- OT161857

Toxic- thanks for the reply. prop if fine. just a recent issue. fuel lines/bulb havent been changed. no warning light from water separator, i install a new filter every year. Will change again to eliminate the possibility. Bob- Thanks for tips. Serial # 12254730T

Most of all, take your time. Once you get it hooked, you can always have someone back you in a little further so you can winch until snug. I put the tailgait down on my sierra to help with being able to stand/sit if necessary. Having a truck with a bed goes along way in helping get in/out on...

Problem fixed by changing out fuel stabilizer diaphragm on port fuel rail. See www.thepelicanservices.com Many optimax owners may be experiencing same/similar situations. Call Todd Moore (The Pelican Services) to see if your Optimax issues can be resolved by replacing the diaphragm. This is...

Bob, tech did the TPS sweep, as per him, no issues were indicated. i have the printout on hand. let me know if that would help. i can scan and email to you. we discussed the hotfoot situation, said that i can disconnect the throttle cable at the motor to eliminate any cable issue at the...

Bob...not working any throttle. After two failed starts today, third attempt started with high rev and settled to approx 750 rpm. Idled a little rougher than i am used to. The engine light came once but didnt stay on. Had throttle position mechanism replaced in fall of 2010. Worked fine in...

Dan, thanks for replying. sorry for the ingnorance. TBI stands for ???